Dropped a Nut or Bolt in the Engine Bay? How to Get It Back

It happens to everyone. A nut slips out of your fingers, bounces once, and vanishes somewhere below the intake. Before you start pulling parts off, take a breath. Most dropped fasteners can be found and recovered in a few minutes if you work methodically.
Step 1: Stop and listen
Don't move anything right away. Think about where you heard it land. A sharp metallic ping usually means it's sitting on a flat surface like a bracket or the subframe. A dull thud often means it landed on a hose, wiring harness or the ground.
Step 2: Check the ground first
Check under the vehicle with a flashlight before searching the engine, since dropped parts often fall straight through. To collect steel pieces, sweep the floor with a magnetic sweeper, a telescoping magnet or even The Magnetic Finger.
Step 3: Search the common catch points
If it didn't hit the floor, it's probably resting on one of these: the top of the transmission or bellhousing, the subframe or crossmember, the splash shield or belly pan, between the engine block and exhaust manifold, or in the recess around the starter. Use a bright light and an inspection mirror to look into areas you can't see directly.
Step 4: Fish it out
A telescoping magnetic pickup tool reaches most steel fasteners, but it doesn't turn corners. For aluminum, stainless or brass parts that a magnet won't grab, use a claw-style mechanical pickup tool. If you can see it but can't reach it, turn your arm and hand into a multi-angle pickup tool with the Magnetic Finger. It slips over your fingertip, and you're ready for action!
Step 5: Never start the engine until it's found
A loose nut sitting near belts, pulleys or the cooling fan can get thrown with real force. And anything dropped into an open intake port, spark plug hole or throttle body has to be found before you go any further. If you can't find it and the intake was open, don't guess.
How to keep it from happening again
The easiest fix is to keep the fastener attached to you. The Magnetic Finger slips over your fingertip and holds screws, nuts and bolts with a magnet, so if your grip slips, the part stays stuck to your finger instead of falling into the engine bay. Pair it with a magnetic parts tray and a rag stuffed below the work area, and dropped parts become rare.
Never drop another bolt
The patented Magnetic Finger holds screws, nuts and bolts on your fingertip so you can start them in tight spots.
Shop Magnetic Finger